C008A BMW Fault Code

Description:

The Transmission Range Sensor (also referred to as the PRNDL input an/or neutral safety switch) tells the transmission control module (TCM) an the engine control module (PCM) that the transmission is in park, reverse, neutral, drive, low, 2nd, 3rd etc. It is attached directly to the manual valve of transmission, so when the shift lever is moved from park to drive, the Transmission Range Sensor communicates this critical information to the above mentioned vehicle control module systems.

C008A Code Symptoms :

If your C008A check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system C008A and engine control unit are in charge of monitoring a bunch of different , and if they get a reading that's a little out of whack, up pops the check engine light.

Diagnosis And Repairing C008A

C008A OBD 2 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.

How to fix C008A code ?

• Engine Control Module (ECM)
• Faulty spark plug (s)
• Incorrect fuel filler cap used
• Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection

Some systems require that the actuator has an adequate supply of brake fluid. Low brake fluid levels can mimic the symptoms of code C008A, so consult the manual to locate the brake fluid reservoir.

Bear in mind that a low fluid level can set code C008A on some applications, so make sure that on fluid operated systems the fluid level is up to the mark before starting an electrical diagnosis.